液化四氟乙烷小孔泄漏试验研究

采用高速摄影技术,考察了液化四氟乙烷发生小孔泄漏时,其水平泄漏和垂直泄漏的初始云团演化行为、泄漏的质量流率、喷射速度和喷射角,并与理论计算公式进行了对比。结果表明:水平喷射两相云团尾部出现涡流,涡流大幅加快了云团向空气中扩散的速率;垂直喷射的两相云团在地面形成液池,液池大幅增加了液化气体向空气中蒸发的速率。水平泄漏试验的喷射角与容器内超压变化规律相似,泄放初期喷射角逐渐增大,经历一段平坦期,到泄放末期喷射角减小。水平泄漏和垂直泄漏的初始喷射速度分别为25 m/s和20 m/s,与理论值26.6 m/s基本吻合。水平泄漏的质量流率的试验值和理论值分别为0.0598 kg/s和0.0684 kg/s,垂直泄漏的分别为0.0472 kg/s和0.059 6 kg/s,结果对比基本吻合,推荐的泄漏质量流率和小孔喷射速度公式可以用于液化四氟乙烷小孔泄漏。     

基于粗糙集理论的危险品运输风险分析

为解决危险品风险分析问题,利用粗糙集理论在处理不确定、不精确问题上的优势,提出基于粗糙集理论的危险品运输风险分析方法。首先,建立决策表,经化简后获得各属性的重要度,识别出影响危险品运输的主要因素与次要因素,以及主次因素所占比例;然后,利用区分函数对决策表进行约简,得出决策表的属性约简;最后,利用决策表的决策规则对原始数据进行推导,得出危险品运输事故的一般规律。结果表明,影响危险品运输事故类型的最重要因素是危险品的类型,所占比重为42.86%,其次是危险品运输的道路状况与危险品运输车辆状况,各占28.57%。在道路状况欠佳且车辆状况良好的前提下,腐蚀品发生危险品事故的严重程度要依次高于毒害品与压缩气体和液化气体。     

含多弱层复合边坡滑坡治理三维数值分析

白音华二号矿滑坡区边坡治理工程是针对稳定性差的南帮非工作帮和南排土场构成的复合边坡进行的。滑坡体受多层弱层控制,治理过程中易导致边坡失稳,所以治理工程采取分区开采的条采方案,充分利用边坡治理的三维效应来进行边坡的失稳破坏研究和稳定性分析。选取滑坡区的典型剖面作为研究对象,基于强度折减方法(SRM),应用有限差分FLAC3D软件,在两种开挖条件下,对含多弱层的复合边坡的稳定性规律和破坏机制进行了数值模拟分析,揭示了多弱层对复合边坡的失稳破坏及稳定性的影响。研究结果表明,治理工程中,弱层被揭露一定宽度,滑体沿煤底板弱层水平错动、竖直方向拉裂破坏;随弱层暴露宽度的增加,边坡稳定性明显降低,说明治理边坡具有三维效应;开挖至3-3煤层底板,开挖坡角20°,弱层暴露宽度为400m,边坡的稳定系数刚好达到安全储备系数1.1,建议矿方首选此方案,可以最大限度的回收煤炭资源。     

落石冲击作用下架设油气管道响应分析

针对影响油气管道安全运营的落石冲击问题,基于弹塑性力学、Cowper-Symonds本构模型和有限元方法,建立了球形落石冲击油气管道的计算模型,对管道动态响应过程进行了数值模拟。对冲击速度、落石半径、管道内压力和落石冲击位置进行了参数敏感性分析,研究了各参数对管道冲击变形的影响规律。结果表明:落石的冲击能量主要用于管道塑性变形;冲击过程中,落石与管道的接触区域由初始的椭圆斑逐渐变成了椭圆环;管道塑性变形随着冲击速度和落石半径的增大而增大,随内压和落石偏移度的增大而减小。该研究工作为油气管道的安全评价及防护工程的设计提供了参考依据,对保障油气安全运输具有重要的工程意义。     

Responses of soil ammonia oxidizers to a short-term severe mercury stress

The responses of soil ammonia-oxidizing archaea(AOA) and ammonia-oxidizing bacteria(AOB) to mercury(Hg) stress were investigated through a short-term incubation experiment.Treated with four different concentrations of Hg(CK,Hg25,Hg50,and Hg100,denoting 0,25,50,and 100 mg Hg/kg dry soil,respectively),samples were harvested after 3,7,and 28 day incubation.Results showed that the soil potential nitrification rate(PNR) was significantly inhibited by Hg stress during the incubation.However,lower abundances of AOA(the highest in CK: 9.20 × 10~7 copies/g dry soil; the lowest in Hg50: 2.68 × 10~7 copies/g dry soil) and AOB(the highest in CK: 2.68 × 10~7 copies/g dry soil; the lowest in Hg50:7.49 × 10~6 copies/g dry soil) were observed only at day 28 of incubation(P 0.05).Moreover,only the community structure of soil AOB obviously shifted under Hg stress as seen through DGGE profiles,which revealed that 2–3 distinct AOB bands emerged in the Hg treatments at day 28.In summary,soil PNR might be a very useful parameter to assess acute Hg stress on soil ecosystems,and the community structure of soil AOB might be a realistic biological indicator for the assessment of heavy metal stress on soil ecosystems in the future.     

Effect of aeration rate on composting of penicillin mycelial dreg

Pilot scale experiments with forced aeration were conducted to estimate effects of aeration rates on the performance of composting penicillin mycelial dreg using sewage sludge as inoculation. Three aeration rates of 0.15, 0.50 and 0.90 L/(min·kg) organic matter(OM) were examined. The principal physicochemical parameters were monitored during the 32 day composting period. Results showed that the higher aeration rate of 0.90 L/(min·kg) did not corresponded to a longer thermophilic duration and higher rates of OM degradation;but the lower aeration rate of 0.15 L/(min·kg) did induce an accumulation of NH+4-N contents due to the inhibition of nitrification. On the other hand, aeration rate has little effect on degradation of penicillin. The results show that the longest phase of thermophilic temperatures ≥ 55°C, the maximum NO-3-N content and seed germination, and the minimum C/N ratio were obtained with 0.50 L/(min·kg) OM. Therefore, aeration rates of0.50 L/(min·kg) OM can be recommended for composting penicillin mycelial dreg.     

Removal kinetics of phosphorus from synthetic wastewater using basic oxygen furnace slag

Removal kinetics of phosphorus through use of basic oxygen furnace slag (BOF-slag) was investigated through batch experiments. Effects of several parameters such as initial phosphorus concentration, temperature, BOF-slag size, initial pH, and BOF-slag dosage on phosphorus removal kinetics were measured in detail. It was demonstrated that the removal process of phosphorus through BOF-slag followed pseudo-first-order reaction kinetics. The apparent rate constant (k_obs) significantly decreased with increasing initial phosphorus concentration, BOF-slag size, and initial pH, whereas it exhibited an opposite trend with increasing reaction temperature and BOF-slag dosage. A linear dependence of k_obs on total removed phosphorus (TRP) was established with k_obs = (3.51 ± 0.11) × 10^− 4 × TRP. Finally, it was suggested that the Langmuir–Rideal (L–R) or Langmuir–Hinshelwood (L–H) mechanism may be used to describe the removal process of phosphorus using BOF-slag.     

Removal kinetics of phosphorus from synthetic wastewater using basic oxygen furnace slag

Removal kinetics of phosphorus through use of basic oxygen furnace slag(BOF-slag)was investigated through batch experiments. Effects of several parameters such as initial phosphorus concentration, temperature, BOF-slag size, initial p H, and BOF-slag dosage on phosphorus removal kinetics were measured in detail. It was demonstrated that the removal process of phosphorus through BOF-slag followed pseudo-first-order reaction kinetics. The apparent rate constant(kobs) significantly decreased with increasing initial phosphorus concentration, BOF-slag size, and initial p H, whereas it exhibited an opposite trend with increasing reaction temperature and BOF-slag dosage.A linear dependence of kobson total removed phosphorus(TRP) was established with kobs=(3.51 ± 0.11) × 10- 4× TRP. Finally, it was suggested that the Langmuir–Rideal(L–R)or Langmuir–Hinshelwood(L–H) mechanism may be used to describe the removal process of phosphorus using BOF-slag.     

Preparation of steel slag porous sound-absorbing material using coal powder as pore former

The aim of the study was to prepare a porous sound-absorbing material using steel slag and fly ash as the main raw material, with coal powder and sodium silicate used as a pore former and binder respectively. The influence of the experimental conditions such as the ratio of fly ash, sintering temperature, sintering time, and porosity regulation on the performance of the porous sound-absorbing material was investigated. The results showed that the specimens prepared by this method had high sound absorption performance and good mechanical properties, and the noise reduction coefficient and compressive strength could reach 0.50 and 6.5 MPa, respectively. The compressive strength increased when the dosage of fly ash and sintering temperature were raised. The noise reduction coefficient decreased with increasing ratio of fly ash and reducing pore former, and first increased and then decreased with the increase of sintering temperature and time. The optimum preparation conditions for the porous sound-absorbing material were a proportion of fly ash of 50% (wt.%), percentage of coal powder of 30% (wt.%), sintering temperature of 1130°C, and sintering time of 6.0 hr, which were determined by analyzing the properties of the sound-absorbing material.     

Discounting in the presence of scarce ecosystem services

The discount rate for cost-benefit analysis has to take account of future scarcity of ecosystem services in consumption and production. Previous literature focuses on the first aspect and shows the importance of the relative price effect, for given growth rates of consumption and ecosystem services. This paper focuses on intermediate ecosystem services in production and shows that for limited substitutability and a low growth rate of these ecosystem services, the growth rate of consumption, and thus the discount rate, declines towards a low value. Using a Ramsey growth model, the paper distinguishes three cases. If ecosystem services can be easily substituted, the discount rate converges to the usual value in the long term. Secondly, if ecosystem services can be easily substituted in production but not in consumption, the relative price effect is important. Finally, and most interestingly, if ecosystem services cannot be easily substituted in production, the discount rate declines towards a low value and the relative price effect is less important. Another part of the previous literature has shown that a declining discount rate is the result of introducing several forms of uncertainty, but this paper reaches that conclusion from an endogenous effect on the growth rate of the economy.